Interface Setup
Interface Setup for PCR-LEPCR-LE2 series
GPIB （optional）
This interface valid only when the optional GPIB interface board is installed.
Attachment of the interface board
GPIB connection
Use a standard IEEE488 cable to connect the PCR-LEPCR-LE2 to the computer.
GPIB configuration
1. Press CONFIG (SHIFT+OPR MODE), COM-I/F, TYPE, and then GPIB.
2. Then, set the address (a value from 1 to 30).
3. Restart the PCR-LEPCR-LE2.
The settings are applied.
GPIB function
| Function | Subset | Description |
|---|---|---|
| Source handshaking | SH1 | Full capability |
| Acceptor handshaking | AH1 | Full capability |
| Talker | T6 | Function available |
| Listener | L4 | Function available |
| Service request | SR1 | Full capability |
| Remote local | RL1 | Full capability |
| Parallel polling | PP0 | No capability |
| Device clear | DC1 | Full capability |
| Device trigger | DT1 | Full capability |
| Controller | C0 | No capability |
| Electrical interface | E1 | Open collector driver |
Service request
Service request and serial polling functions are implemented.
AC Power Supply PCR-LE series