Command (Subsystem)
SENSe Subsystem
During integration, only the queries are valid. If you send one of these commands to settings while the KPM1000 is performing integration, an error (-221, Settings conflict) will occur.
SENS:AVER:COUN | Sets the average count |
---|---|
SENS:CURR:RANG | Sets the current range |
SENS:CURR:RANG:AUTO | Sets the auto current range on/off status |
SENS:FILT | Sets the low pass filter |
SENS:FILT:FREQ | Sets the frequency filter |
SENS:CURR:SCAL | Sets the on/off status of current scaling |
SENS:CURR:SCAL:CTR | Sets the scaling CT ratio |
SENS:SYNC | Sets the synchronization source |
SENS:VOLT:RANG | Sets the voltage range |
SENS:UPD:CYCL | Sets the panel display update interval |
SENS:VOLT:RANG:AUTO | Sets the auto voltage range on/off status |
SENS:VOLT:SCAL | Sets the on/off status of voltage scaling |
SENS:VOLT:SCAL:PTR | Sets the scaling PT ratio |