Overview of Messages
Default Conditions
Conditions after sending a *RST, MEAS:<meter_fn> and at power-on
The following table shows how the KPM1000 is set when the *RST and MEAS:<meter_fn> commands are executed and when the power is turned on.
| Setup item | Setting | Unit | Function | ||
|---|---|---|---|---|---|
| *RST | MEAS:<meter_fn> | At power-on | |||
| SENS:CUR:RANG | 20 | 20 | 20 | -- | Sets the current range |
| SENS:CUR:RANG:AUTO | 1/ON | 0/OFF | 1/ON | -- | Sets the auto current range on/off status |
| SENS:CURR:SCAL | 0/OFF | 0/OFF | 0/OFF | -- | Sets the on/off status of current scaling |
| SENS:CURR:SCAL:CTR | 1 | -- | 1 | -- | Sets the scaling CT ratio |
| SENS:VOLT:RANG | 300 | 300 | 300 | -- | Sets the voltage range |
| SENS:VOLT:RANG:AUTO | 1/ON | 0/OFF | 1/ON | -- | Sets the auto voltage range on/off status |
| SENS:VOLT:SCAL | 0/OFF | 0/OFF | 0/OFF | -- | Sets the on/off status of voltage scaling |
| SENS:VOLT:SCAL:PTR | 1 | -- | 1 | -- | Sets the scaling PT ratio |
| SENS:FILT | 0/OFF | 0/OFF | 0/OFF | -- | Sets the low pass filter |
| SENS:FILT:FREQ | 1/ON | 1/ON | 1/ON | -- | Sets the frequency filter |
| SENS:AVER:COUN | 1 | 1 | 1 | -- | Sets the average count |
| SENS:UPD:CYCL | 0.1 | 0.1 | 0.1 | S | Sets the panel display update interval |
| SENS:SYNC | VOLT | VOLT | VOLT | -- | Sets the synchronization source |
| INTEG:TIM | 0/OFF | 0/OFF | 0/OFF | -- | Sets the on/off status of integration time |
| INTEG:TIM:COUN | 0,1,0 | -- | 0,1,0 | HR,MIN,S | Sets the integration time |
| INIT:CONT:SEQ1/ INIT:CONT:NAME ACQ |
0/OFF | -- | 0/OFF | -- | Sets the auto continue mode |
| TRIG:SOUR | IMM | -- | IMM | -- | Sets the trigger source |
| SYST:KLOC | -- | -- | 0/OFF | -- | Locks panel operations |
| SYST:DISP:CONT 1 | -- | -- | V | -- | Sets the measured value that is shown on the display |
| SYST:DISP:CONT 2 | -- | -- | VA | -- | |
| SYST:DISP:CONT 3 | -- | -- | A | -- | |
| SYST:DISP:CONT 4 | -- | -- | W | -- | |