Processing Time of Commands
The command processing time is the time until the next command is accepted.
It does not include the response time of the hardware.
The processing times indicated here are typical values.
They are not warranted.
Command | GPIB processing time *1 (ms) |
USB processing time (ms) |
RS232C processing time *2 (ms) |
Description |
---|---|---|---|---|
IDN? | 16 | 14 | 12 | Queries the model name |
READ:POW:AC? | 202 | 201 | 200 | Queries the measured active power |
FETC:CURR:AC? | 24 | 21 | 20 | Queries the measured AC current |
SENS:CURR:RANG 1 | 11 | 10 | 9 | Sets the current range |
*RST | 205 | 203 | 202 | Performs a device reset |
*1: Using GPIB-USB-B by National Instruments.
*2: Data rate setting: 38 400 bps. Flow control: On