Kikusui Electronics Corp. :: Communication Interface Manual

Command (Function)

Measurement

If you use the first-level node MEASure, you can set some settings to their default values, perform measurement, and then query the measured values. If you send the MEASure query while the KPM1000 is performing integration, an error (-221, Settings conflict) will occur.

If you use the first-level node READ, you can perform measurement without changing the current settings and then query the measured values.

If you use the first-level node FETCh, you can query the measured values without starting a new measurement.

TRIG:SOUR	Sets the trigger source
INIT INIT:NAME	Initiates the trigger function
TRIG	Software trigger
INIT:CONT:SEQ1 INIT:CONT:NAME	Sets the auto continue mode
ABOR	Aborts the trigger function
MEAS READ FETC	Queries the voltage, AC current, active power, integration time, and integrated power
MEAS:CURR:AC READ:CURR:AC FETC:CURR:AC	Queries the AC current
READ:CURR:AC:INTEG FETC:CURR:AC:INTEG	Queries the integrated current
MEAS:CURR:AMPL:MAX READ:CURR:AMPL:MAX FETC:CURR:AMPL:MAX	Queries the current peak
MEAS:CURR:CRES READ:CURR:CRES FETC:CURR:CRES	Queries the current crest factor
MEAS:FREQ READ:FREQ FETC:FREQ	Queries the frequency
MEAS:POW:AC READ:POW:AC FETC:POW:AC	Queries the active power
MEAS:POW:AC:APP READ:POW:AC:APP FETC:POW:AC:APP	Queries the power (the apparent power)
READ:POW:AC:INTEG FETC:POW:AC:INTEG	Queries the integrated power
MEAS:POW:AC:PFAC READ:POW:AC:PFAC FETC:POW:AC:PFAC	Queries the power factor
MEAS:POW:AC:PHAS READ:POW:AC:PHAS FETC:POW:AC:PHAS	Queries the phase angle
MEAS:POW:AC:REAC READ:POW:AC:REAC FETC:POW:AC:REAC	Queries the power (the reactive power)
READ:TIM:INTEG FETC:TIM:INTEG	Queries the integration time
MEAS:VOLT:AC READ:VOLT:AC FETC:VOLT:AC	Queries the voltage
MEAS:VOLT:AMPL:MAX READ:VOLT:AMPL:MAX FETC:VOLT:AMPL:MAX	Queries the voltage peak
MEAS:VOLT:CRES READ:VOLT:CRES FETC:VOLT:CRES	Queries the voltage crest factor
WAVE	Queries the waveform data