SENS:VOLT:SCAL
Sets the voltage scaling on/off status
Use SENS:VOLT:SCAL:PTR to set the PT ratio.
Command
SENSe:VOLTage:SCALing[:STATe] {ON|OFF|1|0}
SENSe:VOLTage:SCALing[:STATe]?
Parameter
Value | ON (1) | The scaling is turned on. |
OFF (0) | The scaling is turned off (this is the default value). |
Table shows the setting that is specified when *RST is sent.
Response
Returns the voltage scaling on/off status in NR1 format in response to SENS:VOLT:SCAL?.