SENS:VOLT:RANG
Sets the voltage range.
When you use this command to set the range, the auto voltage range feature (SENS:VOLT:RANG:AUTO) is turned off.
Command
SENSe:VOLTage:RANGe[:UPPer] {<numeric>|MINimum|MAXimum}
SENSe:VOLTage:RANGe[:UPPer]?
Parameter
Value | 150 | 150 V range |
300 | 300 V range (This is the default value.) |
Table shows the setting that is specified when *RST is sent.
Response
Returns the voltage range in NR3 format in response to SENS:VOLT:RANG?.