VOLT:PROT:STAT
Turns ON/OFF the undervoltage protection.
Command
[SOURce:]VOLTage:PROTection:STATe {ON|OFF|1|0}
[SOURce:]VOLTage:PROTection:STATe?
Parameter
Value | ON (1) | Undervoltage protection on |
OFF (0) | Undervoltage protection off (default) |
Table shows the setting that is specified when *RST or *RCL is sent.
If a valid VOLT:PROT:UND is specified when undervoltage protectionis off, the undervoltage protection automatically turns on.
Response
Returns the undervoltage protection setting in the NR1 form in response to VOLT:PROT:STAT?