*SRE

Sets the service request enable register.

The service request enable register can be used to select which summary messages in the status byte register will perform service requests.

To clear the service request enable register, send *SRE 0. If the register is cleared, service requests cannot be generated using status information.

Command

*SRE <NRf>

*SRE?

Parameter

Example: Sending *SRE8 sets bit 3 of the service request enable register. Each time the summary bit of the QUEStionable status register (bit 3) in the status byte is set, a service request message is generated.

Response

Returns the value of the service request enable register in NR1 format in response to the *SRE? query.