PROG:FSP:EDIT
Edit an existing fast sequence step. If the parameter is omitted, the current value is retained.
Command
PROGram[:SELected]:FSPeed[:STEP]:EDIT[:POINt] <step_NR1>,<value_numeric>[,<trig_NR1>]
PROGram[:SELected]:FSPeed[:STEP]:EDIT[:POINt]? <step_NR1>
Parameter <step_NR1>
Value: 1 to 1024 (Select the step number you wish to edit.)
Parameter <value_numeric>
Setting for conductance value PLZ-4W PLZ-4WL/ PLZ-4WH
Setting for current value PLZ-4W PLZ-4WL/ PLZ-4WH
Parameter <trig_bool>
Value | ON (1) | Output the trigger signal during step execution |
OFF (0) | Not output the trigger signal during step execution |
Response
Returns the setting of step of the fast sequence (value, trigger on/off) in order in the comma-separated NR3,NR1 form in response to PROG:FSP:EDIT? <step_NR1>.