PROG:NSP:INS
Insert a normal sequence step into the selected program (PROG:NAME). If the parameter is omitted, the last setting value is applied.
Command
PROGram[:SELected]:NSPeed[:STEP]:INSert
<step_NR1>,<value_numeric>,<time_numeric>[,<load_bool>]
[,<ramp_bool>][,<trig_bool>][,<pause_bool>]
Parameter <step_NR1>
Value: 1 to 256 (Select the number previous to the step number you wish to insert.)
Parameter <value_numeric>
Set the setting value which you want to execute by a step.
Setting for conductance value PLZ-4W PLZ-4WL/ PLZ-4WH
Setting for current value PLZ-4W PLZ-4WL/ PLZ-4WH
Parameter <time_numeric>
Value: 0.001 to 3599940 (999h59min), Step execution time
Parameter <load_bool>
Value | ON (1) | Load on (default) |
OFF (0) | Load off |
Parameter <ramp_bool>
Current change type
Value | ON (1) | Slope |
OFF (0) | Step (default) |
Parameter <trig_bool>
Value | ON (1) | Output the trigger signal during step execution |
OFF (0) | Not output the trigger signal during step execution (default) |
Parameter <pause_bool>
Value | ON (1) | Pause during step execution |
OFF (0) | Not pause during step execution (default) |