Command (Function)
System Configuration
Setting tp be related to the Output
OUTP:EXT | Sets the logic of the output on/off using external contact. |
---|---|
OUTP:PON:STAT | Output status at power-on. |
SYST:CONF:MPR | Sets the output-on startup state. (Only on the PAT350-22.8T and PAT850-9.4T) |
Setting of Control source
CURR:EXT:SOUR | Sets the constant current control mode. |
---|---|
VOLT:EXT:SOUR | Sets the CV control mode setting. |
Breaker trip settings when protection activates.
SYST:CONF:BTR:PROT | Turns breaker trip on/off when the OCP/OVP activates. |
---|---|
SYST:CONF:BTR:SHUT | Turns the breaker trip on/off when the SD signal is applied. |
Setting of Parallel Operation
SYST:CONF:PAR | Setting the number of units in Master-Slave Parallel Operation. |
---|---|
SYST:CONF:MSL | Sets the status during parallel operation. |
Setting tp be related to the POWER on/off
SYST:CONF:BTR | Breaker trip. |
---|---|
SYST:CONF:PST | Sets the status signal of the power on/off. |
PAT-T status
SYST:CONF:RSEN | Queries the sensing switch status. |
---|
Setting of the Communication error Display
SYST:CONF:TRAC | Sets whether to display or hide the communication error. |
---|
Setting of the input mode
SYST:CONF:SPH | Sets the phase input mode (Three-phase input/Single-phase input mode). |
---|