Command (Sub-system)
SYSTem subsystem
SYST:CONF:BTR | Breaker trip. |
---|---|
SYST:CONF:BTR:PROT | Turns breaker trip on/off when the OCP/OVP activates. |
SYST:CONF:BTR:SHUT | Turns the breaker trip on/off when the SD signal is applied. |
SYST:CONF:PAR | Setting the number of units in Master-Slave Parallel Operation. |
SYST:CONF:PST | Sets the status signal of the power on/off. |
SYST:CONF:RSEN | Queries the sensing switch status. |
SYST:CONF:MSL | Sets the status during parallel operation. |
SYST:CONF:MPR | Sets the output-on startup state. (Only on the PAT350-22.8T and PAT850-9.4T) |
SYST:CONF:SPH | Sets the phase input mode (Three-phase input/Single-phase input mode) |
SYST:CONF:TRAC | Sets whether to display or hide the communication error. |
SYST:ERR | Read the error information. |
SYST:KLOC | Panel operation lock. |
SYST:LOC | Sets to local. |
SYST:OPT | Queries the option interface board. |
SYST:REM | Sets the operation to remote. Locks the panel keys except the LOCAL switch. |
SYST:RWL | Sets the operation to remote. Locks the panel operation. |
SYST:VERS | Queries the SCPI specification version with which the PAT-T complies. |