Processing time of Commands
The command processing time is the time until the next command is accepted.
It does not include the response time of the hardware.
The processing times indicated here are typical values.
They are not warranted.
Command | GPIB Processing Time *1 (ms) |
USB Processing Time (ms) |
RS232C Processing Time *2 (ms) |
LAN Processing Time *3 (ms) |
Description |
---|---|---|---|---|---|
VOLT | 10 | 10 | 8 | 11 | Sets the voltage. |
MEAS:VOLT? | 30 | 27 | 32 | 27 | Queries the measured voltage output. |
CURR | 10 | 10 | 8 | 11 | Sets the current. |
MEAS:CURR? | 28 | 27 | 32 | 27 | Queries the measured current output. |
*RST | 102 | 102 | 100 | 102 | Performs a device reset. |
*1:Using GPIB-USB-B by National Instruments.
*2:Data rate setting: 19 200 bps, X-Flow control
*3:100BASE-TX Ethernet