Command (Function/ Sub-system)
IEEE488.2 Common commands
| *CLS | Clears all the event registers. |
|---|---|
| *ESE | Sets the event status enable register bits. |
| *ESR | Queries the event status register. |
| *IDN | Queries the identification string (manufacturer information). |
| *OPC | Causes the device to generate the operation complete message in the event status register when all pending selected device operations have been finished. |
| *OPT | Queries the hardware interface board that is installed. |
| *PSC | Initializes *ESE and *SRE. |
| *RST | Performs a device reset. Configures the PAT-T to a known condition independent from the usage history of the device. |
| *SRE | Sets the service request enable register bits. |
| *STB | Reads the status byte and master summary status bits. |
| *TRG | Trigger command |
| *TST | Executes a self-test |
| *WAI | Prevents the device from executing subsequent commands or queries until the No Operation Pending flag becomes true. |