OUTP:EXT
Sets the logic used to control the output on/off using an external contact (J1 connector). This cannot be set when the output is on.
Command
OUTPut:EXTernal {NORMal|INVerted}
OUTPut:EXTernal?
Parameter
Value | NORMal | Turn the output on with a high signal (default) |
INVerted | Turn the output on with a low signal |
For the setting that is applied when *RST is sent, see Table.
Response
Returns the external control logic setting of the output on/off as character data in response to OUTP:EXT?.