Command (Function)
Protection and Clear the Alarm
Overvoltage protection settings
| CURR:PROT | Sets the OCP. |
|---|---|
| CURR:LIM | Queries the current setting limit. |
| CURR:LIM_AUTO | Enables/Disables the current setting limit. |
Overcurrent protection settings
| VOLT:PROT | Sets the OVP. |
|---|---|
| VOLT:LIM | Queries the voltage limit setting. |
| VOLT:LIM_AUTO | Enables/Disables the voltage limit setting. |
Operation when a protection function is activated
| SYST:CONF:BTR:PROT | Turns breaker trip on/off when the OCP/OVP activates. |
|---|---|
| SYST:CONF:BTR:SHUT | Turns the breaker trip on/off when the SD signal is applied. |
Releasing the Alarm
| OUTP:PROT:CLE | Clears the alarm. |
|---|