SYST:CONF:PAR
Sets the number of units in Master-Slave Parallel Operation. It enables to set only for the Master unit. It can not be set when the output is turned on.
Command
SYSTem:CONFigure:PARallel <NRf>
SYSTem:CONFigure:PARallel?
Parameter (On models other than the PAT850-9.4T)
Value 1 to 5 (The default value is 1.)
Parameter (PAT850-9.4T)
Value 1 or 2 (The default value is 1.)
Response
Returns the setting numbers of Master-Slave Parallel Operation in the NR1 form in response to SYST:CONF:PAR?.