Setup

Setting Up the USB Interface

To use the USB interface to control the PLZ12005WH/PLZ20005WH, a driver that supports the USB T&M class (USBTMC) must be installed on the controller. The USBTMC driver is installed automatically by the VISA library.

Connection Procedure

Turn off the POWER switches of the PLZ12005WH/PLZ20005WH and computer.

Using a USB cable, connect the PLZ12005WH/PLZ20005WH to the PC and then turn on the PLZ12005WH/PLZ20005WH.

Service request

The PLZ12005WH/PLZ20005WH is equipped with service request and serial polling functions.

USB feature

Complies with USB specification 2.0

Complies with the USBTMC-USB488 device class specifications

Baud rate: 480 Mbps max. (High Speed)

Message terminator: LF or EOM during reception, LF + EOM during transmission

VID (vendor ID)

0x0B3E

PID (product ID)

0x1042 (for all models)

NOTE

If you are going to use remote control, we recommend that you set the PLZ12005WH/PLZ20005WH in remote mode (set SYST:COMM:RLST to REMote or RWLock). When operating in remote mode, REMOTE appears on the front panel display.

>top