VOLT:LIM:AUTO
Sets whether to enable the voltage limit setting. If enabled, the voltage limit setting is automatically set to approximately 95 % of the OVP trip point. This cannot be set when the output is on.
Command
[SOURce:]VOLTage:LIMit:AUTO {ON|OFF|1|0}
[SOURce:]VOLTage:LIMit:AUTO?
Parameter
Value | ON(1) | Limit the voltage setting |
OFF(0) | Not limit the voltage setting (default) |
For the setting that is applied when *RST is sent, see Table.
Response
Returns whether to enable the voltage limit setting in the NR1 form in response to VOLT:LIM:AUTO?.