CURR:LIM:AUTO
Sets whether to enable the current setting limit. If enabled, the current setting limit is automatically set to approximately 95 % of the OCP trip point. This cannot be set when the output is on.
Command
[SOURce:]CURRent:LIMit:AUTO {ON|OFF|1|0}
[SOURce:]CURRent:LIMit:AUTO?
Parameter
Value | ON(1) | Limit the current setting |
OFF(0) | Not limit the current setting (default) |
For the setting that is applied when *RST is sent, see Table.
Response
Returns whether to enable the current setting limit in the NR1 form in response to CURR:LIM:AUTO?.