CURR:TRIG
Set the current when a trigger is activated.
Command
[SOURce:]CURRent[:LEVel]:TRIGgered[:AMPLitude] {<current>|MINimum|MAXimum}
Parameter PLZ-4W PLZ-4WL/ PLZ-4WH
Table shows the setting that is specified when *RST or *RCL is sent.
 |
 |
Overview
Setup
Overview of Messages
Command (function search)
- IEEE488.2 Common Commands
- Measurement Condition
- Protection and Clear the Alarm
- Load On/Off
- Measure and Trigger
- ABC Preset memories
- Sequence
- System
- Register
Command (ABC search)
Command (Sub-system search)
Appendix
Tutorial