Multichannel
Multichannel Commands
-> Multichannel Commands (Subsystem)
Output settings for all channels
| GLOB:OUTP | Turns output on/off for all channels |
|---|---|
| GLOB:VOLT | Sets the voltage of all channels |
| GLOB:CURR | Sets the current of all channels |
Channel specification
| INST | Specifies the channel to configure |
|---|
Checking the multichannel configuration
| INST:CAT | Checks the channel configuration |
|---|
OPERation:INSTrument subregister
| STAT:OPER:INST | Event |
|---|---|
| STAT:OPER:INST:COND | Register condition |
| STAT:OPER:INST:ENAB | Enable |
| STAT:OPER:INST:NTR | Negative transition |
| STAT:OPER:INST:PTR | Positive transition |
OPERation:INSTrument:ISUMmary<n> subregister
| STAT:OPER:INST:ISUM<n> | Event |
|---|---|
| STAT:OPER:INST:ISUM<n>:COND | Register condition |
| STAT:OPER:INST:ISUM<n>:ENAB | Enable |
| STAT:OPER:INST:ISUM<n>:NTR | Negative transition |
| STAT:OPER:INST:ISUM<n>:PTR | Positive transition |
QUEStionable:INSTrument subregister
| STAT:QUES:INST | Event |
|---|---|
| STAT:QUES:INST:COND | Register condition |
| STAT:QUES:INST:ENAB | Enable |
| STAT:QUES:INST:NTR | Negative transition |
| STAT:QUES:INST:PTR | Positive transition |
QUEStionable:INSTrument:ISUMmary<n> subregister
| STAT:QUES:INST:ISUM<n> | Event |
|---|---|
| STAT:QUES:INST:ISUM<n>:COND | Register condition |
| STAT:QUES:INST:ISUM<n>:ENAB | Enable |
| STAT:QUES:INST:ISUM<n>:NTR | Negative transition |
| STAT:QUES:INST:ISUM<n>:PTR | Positive transition |
Regurated DC Power Supply PWX Series