Command for DCS
These commands are valid when the emulation is set to DCS (SYST:COMM:EMUL DCS).
| OUTP:ISOL | Sets the isolation relay control signal ON or OFF. |
|---|---|
| OUTP:SENS | Sets the sens relay signal open or close. |
| SYST:NET:TERM | Sets the terminators. |
Regurated DC Power Supply PWX series
Communication Interface Manual
Overview
Setup
Overview of Messages
Command (function search)
- IEEE488.2 Common Commands
- Output Setting
- Protection and Clear the Alarm
- System Configuration
- Setting Changes using triggers
- Measurement
- System
- Register
Command (ABC search)
Command (Sub-system search)
Register
Appendix
Tutorial
Multi channel (VMCB)
Command for DCS
Regurated DC Power Supply PWX Series
Communication Interface Manual