RES
Sets the internal resistance.
If the variable internal resistance feature (factory options) is in use, this command is valid.
If you are not using the variable internal resistance feature, set this to 0.
Command
[SOURce:]RESistance {<numeric>|MINimum|MAXimum}
[SOURce:]RESistance? {MINimum|MAXimum}
Parameter
| Value | 0 to the rated output voltage/ rated output current (The default value is 0.) |
| Unit | OHM |
| A SCPI error (-222, "Data out of range") occurs if outside the range. | |
Response
Returns the internal resistance setting in NR3 format in response to RES?.
Regurated DC Power Supply PWX Series