Multichannel
Multichannel Commands (Subsystem)
GLOBal subsystem
Insert a wait of at least 200 ms after sending a GLOBal subsystem command.
| GLOB:CURR | Sets the current of all channels |
|---|---|
| GLOB:OUTP | Turns output on/off for all channels |
| GLOB:VOLT | Sets the voltage of all channels |
INSTrument subsystem
| INST:CAT | Checks the channel configuration |
|---|---|
| INST | Specifies the channel to configure |
STATus subsystem
| STAT:OPER:INST | OPER:INST subregister: event |
|---|---|
| STAT:OPER:INST:COND | OPER:INST subregister: register condition |
| STAT:OPER:INSTR:ENAB | OPER:INST subregister: enable |
| STAT:OPER:INST:PTR | OPER:INST subregister: negative transition |
| STAT:OPER:INST:NTR | OPER:INST subregister: positive transition |
| STAT:OPER:INST:ISUM<n> | OPER:INST:ISUM subregister: event |
| STAT:OPER:INST:ISUM<n>:COND | OPER:INST:ISUM subregister: register condition |
| STAT:OPER:INSTR:ISUM<n>:ENAB | OPER:INST:ISUM subregister: enable |
| STAT:OPER:INST:ISUM<n>:PTR | OPER:INST:ISUM subregister: negative transition |
| STAT:OPER:INST:ISUM<n>:NTR | OPER:INST:ISUM subregister: positive transition |
| STAT:QUES:INST | QUES:INST subregister: event |
| STAT:QUES:INST:COND | QUES:INST subregister: register condition |
| STAT:QUES:INST:ENAB | QUES:INST subregister: enable |
| STAT:QUES:INST:PTR | QUES:INST subregister: negative transition |
| STAT:QUES:INST:NTR | QUES:INST subregister: positive transition |
| STAT:QUES:INST:ISUM<n> | QUES:INST:ISUM subregister: event |
| STAT:QUES:INST:ISUM<n>:COND | QUES:INST:ISUM subregister: register condition |
| STAT:QUES:INST:ISUM<n>:ENAB | QUES:INST:ISUM subregister: enable |
| STAT:QUES:INST:ISUM<n>:PTR | QUES:INST:ISUM subregister: negative transition |
| STAT:QUES:INST:ISUM<n>:NTR | QUES:INST:ISUM subregister: positive transition |
Regurated DC Power Supply PWX Series