INIT:CONT:SEQ1 and INIT:CONT:NAME

These commands set the measurement conditions in sequence operation auto continue mode.

When the sequence operation auto continue mode is turned on

If the trigger source parameter is set to IMM, the measurement starts immediately. When the operation is complete, a new measurement automatically starts.

If the parameter is set to BUS, the measurement starts after receiving a software trigger. When the operation is complete, the KPM1000 waits for the next trigger.

When the sequence operation auto continue mode is turned off

The measurement currently in progress continues unless ABOR is sent. New measurements are not automatically continued.

Command

INITiate:CONTinuous:SEQuence1 {ON|OFF|1|0}

INITiate:CONTinuous:SEQuence1?

INITiate:CONTinuous:NAME ACQuire,{ON|OFF|1|0}

INITiate:CONTinuous:NAME?

Parameter

Value	ON (1)	Auto continue mode on
	OFF (0)	Auto continue mode off (default)

For the setting that is applied when *RST is sent, see Table.

Response

Returns the sequence operation auto continue mode setting in NR1 format in response to INIT:CONT:SEQ1? or INIT:CONT:NAME ACQ.