Command (Function)
Protection and Clearing Alarms
Setting frequency limits
| FREQ:LIM | Sets the frequency upper limit |
|---|---|
| FREQ:LIM:LOW | Sets the frequency lower limit |
Setting current limits
| CURR | Sets the AC current upper limit |
|---|---|
| CURR:OFFS | Sets the DC current upper limit |
| CURR:PROT:STAT | Action that is performed when the current limit is exceeded |
| CURR:PROT:TRIP:TIME | Sets the time until the protection function trips when the current limit is exceeded |
| CURR:PROT:OCP2:TIME | Sets the time that must elapse after the internal semiconductor protection is activated before an alarm is generated |
| CURR:PEAK | Sets the peak limit of the positive electric potential |
| CURR:PEAK:LOW | Sets the peak limit of the negative electric potential |
Setting voltage limits
| VOLT:LIM | Sets the AC voltage upper limit |
|---|---|
| VOLT:LIM:LOW | Sets the AC voltage lower limit |
| VOLT:OFFS:LIM | Sets the DC voltage upper limit |
| VOLT:OFFS:LIM:LOW | Sets the DC voltage lower limit |
Setting OVP and UVP
| VOLT:OFFS:PROT:LEV | Sets the OVP value to use to judge averaged voltage measurements |
|---|---|
| VOLT:OFFS:PROT:LEV:LOW | Sets the UVP value to use to judge averaged voltage measurements |
| VOLT:PROT:LEV | Sets the OVP value used to judge rms voltage measurements |
| VOLT:PROT:LEEV:LOW | Sets the UVP value used to judge rms voltage measurements |
Clearing alarms
| OUTP:PROT:CLE | Clears alarms |
|---|
Protection and Clearing Alarms
(Single-phase, three-wire output/ Three-phase output)
| CURR{1|2|3} | Sets the AC current upper limit of each phase |
|---|---|
| CURR{1|2|3}:OFFS | Sets the DC current upper limit of of each phase |
| CURR{1|2|3}:PEAK | Sets the peak limit of the positive electric potential of each phase |
| CURR{1|2|3}:PEAK:LOW | Sets the peak limit of the negative electric potential of each phase |
AC Power Supply PCR-LE series