Command (Function)
Measured Value Queries
The second level nodes are SEQuence3 and ACQuire. Regardless of which node you use, the PCR operates in the same way when it receives the commands.
If you use the root node MEASure, the measurement is performed, and then the measured value is queried. If you use FETC, the measured value is queried without a measurement being performed.
| TRIG:SEQ3:SOUR TRIG:ACQ:SOUR |
Sets the trigger source of the sequence 3 group |
|---|---|
| INIT:SEQ3 | Starts the trigger function of the sequence 3 group |
| INIT:NAME | Starts the trigger function of the specified sequence group |
| TRIG:SEQ3 TRIG:ACQ |
Sequence 3 group software trigger |
| INIT:CONT:SEQ3 INIT:CONT:NAME |
Sets the auto continue mode |
| SENS:AVER | Sets the averaging period of measured values |
| ABOR | Aborts the trigger function |
| MEAS:CURR:DC FETC:CURR:DC |
Queries the DC current |
| MEAS:CURR:AC FETC:CURR:AC |
Queries the AC current |
| MEAS:CURR:AMP:MAX FETC:CURR:AMP:MAX |
Queries the peak current |
| SENS:HOLD | Sets the hold time of the peak current |
| MEAS:CURR:AMP:MAX:HOLD FETC:CURR:AMP:MAX:HOLD |
Queries the peak current (the held value) |
| SENS:CURR:PEAK:CLE | Clears the held measured peak current |
| MEAS:FREQ FETC:FREQ |
Queries the frequency |
| MEAS:POW:AC FETC:POW:AC |
Queries the AC power (the actual power) |
| MEAS:POW:AC:APP FETC:POW:AC:APP |
Queries the AC power (the apparent power) |
| MEAS:POW:AC:REAC FETC:POW:AC:REAC |
Queries the AC power (the reactive power) |
| MEAS:POW:AC:PFAC FETC:POW:AC:PFAC |
Queries the power factor of the AC power |
| MEAS:POW:DC FETC:POW:DC |
Queries the DC power |
| MEAS:VOLT:DC FETC:VOLT:DC |
Queries the DC voltage |
| MEAS:VOLT:AC FETC:VOLT:AC |
Queries the AC voltage |
AC Power Supply PCR-LE series