TRIG:SEQ2:SOUR
TRIG:OUTP:SOUR
Sets the condition (trigger source) for actually starting the delay action after the sequence 2 group receives INIT:SEQ2 / INIT:NAME OUTP.
The output turns on or off after the delay elapses.
Command
TRIGger:SEQuence2:SOURce {IMMediate|BUS}
TRIGger:SEQuence2:SOURce?
TRIGger:OUTPut:SOURce {IMMediate|BUS}
TRIGger:OUTPut:SOURce?
Parameter
Value | IMM | Start the delay action immediately |
BUS | Wait for a software trigger (*TRG, TRIG:SEQ2, or IEEE488.1 get (Group Execute Trigger)) to start the delay action |
For the setting that is applied when *RST is sent, see Table.
Response
Queries the trigger source setting for the sequence 2 group as character data in response to TRIG:SEQ2:SOUR? / TRIG:OUTP:SOUR?.