VOLT:TRIG
Sets the voltage that is applied when INIT:TRAN and a software trigger are sent.
When the PWX is set so that constant voltage is controlled externally (VOLT:EXT:SOUR VOLT), settings performed by this command are invalid.
Command
[SOURce:]VOLTage[:LEVel]:TRIGgered[:AMPLitude] {<numeric>|MINimum|MAXimum}
[SOURce:]VOLTage[:LEVel]:TRIGgered[:AMPLitude]? {MINimum|MAXimum}
Parameter
| Value | A value in the range of the VOLT:LIM:LOW setting to 105 % of the rated output voltage (the default value is 0 V) |
| Unit | V |
| A SCPI error (-222, "Data out of range") occurs if outside the range. | |
For the setting that is applied when *RST or *RCL is sent, see this table.
Response
Returns the voltage value that is applied when a trigger is received in NR3 format in response to VOLT:TRIG?.
Regurated DC Power Supply PWX Series