Setup
Interface Setup
GPIB (Optional)
This interface valid only when the factory option GPIB interface board is installed.
GPIB connection
Use a standard IEEE488 cable to connect the PAT-T to the computer.
GPIB configuration
1. Select GPIB (CF54: GPIb) in the CONFIG settings.
2. Set the address (CF51: 1 to 30) in the CONFIG settings.
The address is set to 1 as factory default setting.
GPIB function
| Function | Subset | Description |
|---|---|---|
| Source handshaking | SH1 | Full capability |
| Acceptor handshaking | AH1 | Full capability |
| Talker | T6 | Function available |
| Listener | L4 | Function available |
| Service request | SR1 | Full capability |
| Remote local | RL1 | Full capability |
| Parallel polling | PP0 | No capability |
| Device clear | DC1 | Full capability |
| Device trigger | DT1 | Full capability |
| Controller | C0 | No capability |
| Electrical interface | E1 | Open collector driver |
Service request
Service request and serial polling functions are implemented.