INTEG:TIM:COUN

Sets the integration time.

This command is valid when the integration time has been enabled (INTEG:TIM has been sent with parameter ON).

During integration, only the queries are valid. If you send one of these commands to settings while the KPM1000 is performing integration, an error (-221, Settings conflict) will occur.

Command

INTEGrate:TIMer:COUNt <Hour_NR1>,<Min_NR1>,<Sec_NR1>

INTEGrate:TIMer:COUNt?

Parameter <Hour_NR1>,<Min_NR1>,<Sec_NR1>

Value 1 minute to 9999 hours and 59 minutes (The default value is 1 minute.)
Unit <Hour_NR1>:HR
<Min_NR1>:MIN
<Sec_NR1>:s

Table shows the setting that is specified when *RST is sent.

Response

Returns the integration time in NR1,NR1,NR1 format (a comma-separated list in which the data is in the order of hours, minutes, and seconds) in response to INTEG:TIM:COUN?.

Overview

Setup

Overview of Messages

Command (function search)

Command (ABC search)

Command (Sub-system search)

Appendix

Tutorial