INTEG:TIM

Enables and disables the integration time.

Use INTEG:TIM:COUN to set the integration time.

During integration, only the queries are valid. If you send one of these commands to settings while the KPM1000 is performing integration, an error (-221, Settings conflict) will occur.

Command

INTEGrate:TIMer[:STATe] {ON|OFF|1|0}

INTEGrate:TIMer[:STATe]?

Parameter

Value ON (1) The integration time is enabled.
OFF (0) The integration time is disabled (this is the default value).

Table shows the setting that is specified when *RST is sent.

Response

Returns whether the integration time is enabled in NR1 format in response to INTEG:TIM?.

Overview

Setup

Overview of Messages

Command (function search)

Command (ABC search)

Command (Sub-system search)

Appendix

Tutorial