Kikusui Electronics Corp. :: Communication Interface Manual

Regurated DC Power Supply PWX series

Communication Interface Manual

SYST:LOC

Sets the PWX to local mode (Remote Disable; the REMOTE LED turns off). This is a substitute command for the IEEE488.1 ren FALSE (remote disable) command. The Remote Disable state enables both panel operations and commands.

Use SYST:REMor SYST:RWL to switch to remote mode (Remote Enable; the REMOTE LED lights).

If the communication monitoring timer is set, set the timer to off (OUTP:PROT:WDOG 0) before switching to local mode.

Command

SYSTem:LOCal

Overview

Introduction

Setup

Installing the VISA library
Interface Setup

Overview of Messages

Command Syntax
Parameters
Default settings

Command (function search)

IEEE488.2 Common Commands
Output Setting
Protection and Clear the Alarm
System Configuration
Setting Changes using triggers
Measurement
System
Register

Command (ABC search)

A C D G I M O R S T V *

Command (Sub-system search)

SOURce
OUTPut
MEASure
TRIGger
SYSTem/DISPlay
STATus
IEEE488.2 Common Command
List (PDF)

Architecture
Register structure

Appendix

Instrument Interface Standards
A List of Errors
Processing time of main command
FAQ

Tutorial

Setting and measurment
Using Triggers
Status Monitoring
Error Checking
Visual Basic 2008

Multi channel (VMCB)

Setup
Commands of multichannnel
Registers
Tutorial

Command for DCS

Command

Regurated DC Power Supply PWX Series
Communication Interface Manual