Kikusui Electronics Corp. :: Communication Interface Manual

Regurated DC Power Supply PWX series

Communication Interface Manual

SYST:ERR:TRAC

Sets whether to display communication errors by performing a debug trace. If the debug trace function is turned on, error codes (example: Err-100) are shown on the PWX display.

Command

SYSTem:ERRor:TRACe {ON|OFF|1|0}

SYSTem:ERRor:TRACe?

Parameter

Value	ON (1)	Communication errors are displayed.
	OFF (0)	Communication errors are not displayed.

Response

Returns whether communication errors are displayed in NR1 format in response to SYST:ERR:TRAC?

Overview

Introduction

Setup

Installing the VISA library
Interface Setup

Overview of Messages

Command Syntax
Parameters
Default settings

Command (function search)

IEEE488.2 Common Commands
Output Setting
Protection and Clear the Alarm
System Configuration
Setting Changes using triggers
Measurement
System
Register

Command (ABC search)

A C D G I M O R S T V *

Command (Sub-system search)

SOURce
OUTPut
MEASure
TRIGger
SYSTem/DISPlay
STATus
IEEE488.2 Common Command
List (PDF)

Architecture
Register structure

Appendix

Instrument Interface Standards
A List of Errors
Processing time of main command
FAQ

Tutorial

Setting and measurment
Using Triggers
Status Monitoring
Error Checking
Visual Basic 2008

Multi channel (VMCB)

Setup
Commands of multichannnel
Registers
Tutorial

Command for DCS

Command

Regurated DC Power Supply PWX Series
Communication Interface Manual