CURR:PROT
Sets the overcurrent protection (OCP) value.
Command
[SOURce:]CURRent:PROTection[:LEVel] {<numeric>|MINimum|MAXimum}
[SOURce:]CURRent:PROTection[:LEVel]? {MINimum|MAXimum}
Parameter
| Value | Approximately 105 % to 110 % of the present current value (CURR; the default value is 111.5 % of the rated output current) If you attempt to specify a value that is 105 % of the current value or less, an SCPI error (-222, "Data out of range") will occur. If the PWX is set so that constant current is being controlled externally (CURR:EXT:SOUR VOLT), you can specify 10 % to 111.5 % of the rated output current. |
| Unit | A |
For the setting that is applied when *RST or *RCL is sent, see this table.
Response
Returns the OCP value in NR3 format in response to CURR:PROT?.
Regurated DC Power Supply PWX Series