CURR:LIM:AUTO
Enables or disables the limit on the current setting.
If you enable the limit when the OCP setting is lower than the current setting, the OCP setting will be set to 105 % of the current setting.
Command
[SOURce:]CURRent:LIMit:AUTO {ON|OFF|1|0}
[SOURce:]CURRent:LIMit:AUTO?
Parameter
| Value | ON (1) | The current setting limit is enabled. |
| OFF (0) | The current setting limit is disabled (default). |
For the setting that is applied when *RST or *RCL is sent, see this table.
Response
Returns whether the limit on the current setting is enabled in NR1 format in response to CURR:LIM:AUTO?
Regurated DC Power Supply PWX Series