CURR
Sets the current.
When the PWX is set so that constant current is controlled externally (CURR:EXT:SOUR VOLT), settings performed by this command are invalid.
Command
[SOURce:]CURRent[:LEVel][:IMMediate][:AMPLitude] {<numeric>|MINimum|MAXimum}
[SOURce:]CURRent[:LEVel][:IMMediate][:AMPLitude]? {MINimum|MAXimum}
Parameter
| Value | 0 % to 105 % of the rated output current (The default value is 105 % of the rated output current.) |
| Unit | A |
| A SCPI error (-222, "Data out of range") occurs if outside the range. | |
For the setting that is applied when *RST or *RCL is sent, see this table.
Response
Returns the current setting in NR3 format in response to CURR?.
Regurated DC Power Supply PWX Series