MEAS{1|2|3}:CURR:CRES/ FETC{1|2|3}:CURR:CRES
MEAS{1|2|3}:CURR:CRES? starts a new measurement and then queries the current crest factor of the specified phase.
FETC{1|2|3}:CURR:CRES? queries the current crest factor of the specified phase without starting a new measurement.
This command is valid in single-phase three-wire output or three-phase output (PCR-LE optional).
The valid modes (parameters to the OUTP:COUP command) is AC.
Command
U phase
MEASure1[:SCALar]:CURRent:CREStfactor?
FETCh1[:SCALar]:CURRent:CREStfactor?
V phase
MEASure2[:SCALar]:CURRent:CREStfactor?
FETCh2[:SCALar]:CURRent:CREStfactor?
W phase (Three-phase output only)
MEASure3[:SCALar]:CURRent:CREStfactor?
FETCh3[:SCALar]:CURRent:CREStfactor?
Response
Returns the current crest factor of U phase in NR3 format in response to MEAS1:CURR:CRES? or FETC1:CURR:CRES?.
Returns the current crest factor of V phase in NR3 format in response to MEAS2:CURR:CRES? or FETC2:CURR:CRES?.
Returns the current crest factor of W phase in NR3 format in response to MEAS3:CURR:CRES? or FETC3:CURR:CRES?.
AC Power Supply PCR-LE series