SYST:BACK

Saves the panel settings and the configuration settings.

The settings you have made in remote mode are saved to the KPM1000 when you switch from remote mode to local mode.

If you turn the KPM1000 off while it is in remote mode without first saving the settings, the settings you have made will be lost, and the KPM1000 will start with the settings that were being used prior to it being switched to remote mode.

If you send the SYST:BACK command, the current panel settings and configuration settings will be saved to the KPM1000. If you then turn the KPM1000 off while it is in remote mode, the KPM1000 will start with the settings that were being used when you sent the SYST:BACK command.

Command

SYSTem:BACKup