Setup
Interface Setup
USB (Option)
This interface is valid only when the factory option USB interface board is installed.
A device driver supporting USB T&M Class (USBTMC) is required to control the KPM1000 through the USB interface. The USBTMC driver is automatically installed by the VISA library.
USB connection
Use a standard USB cable to connect the KPM1000 to the computer.
USB configuration
1. Press I/F.
"SELECt" is displayed in the settings.
2. Press DISP D until "uSb" is displayed.
3. Restart the KPM1000.
The settings are applied.
Service request
Service request and serial polling functions are implemented.
USB function
Complies with USB Specification 2.0
Complies with USBTMC Specification 1.0 and USBTMC-USB488 Specification 1.0
Data rate: 12 Mbps maximum (full speed)
VID (Vender ID)
0x0B3E
PID (Product ID)
0x102E