Setup

Interface Setup

GPIB (Option)

This interface valid only when the factory option GPIB interface board is installed.

GPIB connection

Use a standard IEEE488 cable to connect the KPM1000 to the computer.

GPIB configuration

1.  Press I/F.

"SELECt" is displayed in the settings.

2.  Press DISP D until "GPIb" is displayed.

3.  Press DISP C until "AddrESS" is displayed.

4.  Press the Δ∇ or DISP D to select the GPIB address (1 to 30).

5.  Restart the KPM1000.

The settings are applied.

GPIB function

 

Function Subset Description
Source handshaking SH1 Full capability
Acceptor handshaking AH1 Full capability
Talker T6 Function available
Listener L4 Function available
Service request SR1 Full capability
Remote local RL1 Full capability
Parallel polling PP0 No capability
Device clear DC1 Full capability
Device trigger DT1 Full capability
Controller C0 No capability
Electrical interface E1 Open collector driver

Service request

Service request and serial polling functions are implemented.

>top

Overview

Setup

Overview of Messages

Command (function search)

Command (ABC search)

Command (Sub-system search)

Appendix

Tutorial