Command (function search)
Load condition settings
Operation mode
| FUNC | Sets the operation mode |
|---|---|
| FUNC:CVOP | Enables/disables +CV mode |
Range
| COND:RANG | Sets the conductance range |
|---|---|
| CURR:RANG | Sets the current range |
| POW:RANG | Sets the power range |
| VOLT:RANG | Sets the voltage range |
Setting values
| COND | Sets the conductance |
|---|---|
| CURR | Sets the current |
| POW | Sets the power |
| VOLT | Sets the voltage |
Slew rate
| CURR:SLEW | Sets the slew rate |
|---|
Soft start
| CURR:SST | Sets the soft start time |
|---|
Short function
| INP:SHOR OUTP:SHOR |
Sets the short function |
|---|
Response speed
| COND:RESP | Sets the response speed in CR mode |
|---|---|
| VOLT:RESP | Sets the response speed in CV mode |
Switching
| COND:PULS:LEV | Sets the switching conductance |
|---|---|
| CURR:PULS:LEV | Sets the switching current |
| COND:PULS:FREQ | Sets the switching frequency |
| CURR:PULS:FREQ | |
| COND:PULS:DCYC | Sets the switching duty cycle |
| CURR:PULS:DCYC |
Remote sensing
| SYST:CONF:RSEN | Enables/disables remote sensing |
|---|
Electronic Load PLZ-5W series