PROG:VOLT:PROT:STAT
Enables or disables the undervoltage protection (UVP) in the program selected by PROG.
When enabled, the PLZ-5W turns the load off during UVP operation. You can set the UVP voltage value with PROG:VOLT:PROT:LOW.
Command
[SOURce:]PROGram[:SELected]:VOLTage:PROTection:STATe {ON|OFF|1|0}
[SOURce:]PROGram[:SELected]:VOLTage:PROTection:STATe?
Parameter
| Value | ON(1) | Enabled |
|---|---|---|
| OFF(0) | Disabled | |
| Factory default | OFF(0) |
Response
Returns the whether the UVP in the selected program is enabled in boolean format in response to the PROG:VOLT:PROT:STAT? query.
Electronic Load PLZ-5W series