SENS:AVER
Sets the averaging period of the measured values (excluding the peak current).
Command
SENSe:AVERage[:STATe] {ON|OFF|1|0}
SENSe:AVERage[:STATe]?
Parameter
| Value | ON(1) | Displays the moving average over approximately 3 seconds |
| OFF(0) | Update every approximately 0.3 seconds (default) |
For the setting that is applied when *RST is sent, see this table
For the setting that is applied when *RST is sent, see this table
For the setting that is applied when *RST is sent, see this table
Response
Response
Returns the averaging period of the measured values in NR1 format in response to SENS:AVER?.
AC Power Supply PCR-LE series