Sequence tutorial

Below are tutorials for creating sequences.v

• Sequence creation basics

 

Describes basic sequence settings (voltage, frequency, and ramp).

• Voltage sweep and frequency sweep

 

Describes how to sweep a waveform using the ramp function.

• Switching steps at specific phase angles

 

Describes how to start subsequent steps from specified angles after previous steps are completed. The phase is continuous.

• Suddenly changing the phase

 

Describes how to suddenly change the phase between steps.

• Single-phase, three-wire output and three-phase output basics

 

Describes the waveforms that are produced for single-phase, three-wire output and three-phase output.

• Phase setting for multi-phase output

 

Describes how to set a sequence so that the phase suddenly changes for multi-phase output.

• Phase sweep

 

Describes how to set a sequence so that the phase is swept for multi-phase output.

• Line voltage dip

 

Describes how to set a line voltage dip.

 

TOP

• << MANUAL Top