RMT CONT SOFTWARE FOR PCR-LE/PCR-WE SD021-PCR-LE
Operation Guide
SD021-PCR-LE/WE Control Procedure
This section explains the basic procedure to control the PCR from SD021-PCR-LE/WE.
1 |
Select the PCR series you want to control. Select using the IP address. |
2 |
To control a PCR-LE2/ PCR-WE2, select the output method. Select single-phase output, single-phase three-wire output, or three-phase output. |
3 |
Select the output voltage mode. Select AC output or DC output. |
4 |
Select the output voltage range. Select high range or low range. |
5 |
Set the voltage and frequency. |
6 |
Turn the output on. |
7 |
Start the monitor. You can now monitor the current, voltage, power, power factor, and frequency. |
RMT CONT SOFTWARE FOR PCR-LE/PCR-WE SD021-PCR-LE
Operation Guide