Soft start
Sets the soft start rising time and executes soft start (rising edge). If the command is set during the soft start rise time, the new value takes effect.
Command
INPut:SSTart:RISE {<numeric>|MIN|MAX|DEF}
Parameter
| Value: | 0 to 7 200 (default: 0) |
| Unit: | S (second) |
Table 4 shows the setting that is specified when *RST or *RCL is sent.
Sets the soft start falling time and executes soft start (falling edge). If the command is set during the soft start fall time, the new value takes effect.
Command
INPut:SSTart:FALL {<numeric>|MIN|MAX|DEF}
Parameter
| Value: | 0 to 7 200 (default: 0) |
| Unit: | S (second) |
Table 4 shows the setting that is specified when *RST or *RCL is sent.
Queries the remaining time of soft start rising edge or soft start falling edge.
Command
INPut:SSTart:RTIMe?
Response
Returns the remaining time of soft start rising edge or falling edge in the NR1 form in response to INP:SST:RTIM?.
| Unit: | S (second) |