Overview of Messages | Command Syntax
Parameters | Default settings

Parameters

The parameter format of SCPI is derived from the program parameter format defined in IEEE 488.2.

The representation system of the program data that the KFM2150 handles is indicated below.

Non-numeric parameters

- String data

String data is used when a series of ASCII characters are requested.

Enclose a string in single quotations or double quotations. The start and end quotation marks must match.

FUNCtion "IMP"

If you wish to use a quotation mark as a part of the string, enter two quotation marks consecutively (with no characters in between).

- Character data

Character data is used when only a limited number of values is available for the program setting. Responses are returned in the short form.

TRIGger:SOURce {BUS|IMMediate|TIMer}

- Boolean data

Boolean data expresses a 1 or 0 condition or an ON or OFF condition. Responses are returned as 1 or 0.

INPut {ON|OFF|1|0}

Numeric parameters

- NR1

Represents an integer.

Details are given in the IEEE 488.2 Standard Digital Interface for Programmable Instrumentation.

- NR2

Represents a real number (floating point).

Details are given in the IEEE 488.2 Standard Digital Interface for Programmable Instrumentation.

- NR3

Represents a real number (exponential).

Details are given in the IEEE 488.2 Standard Digital Interface for Programmable Instrumentation.

The value +3.80000+E02 is returned for the response data 380. The number of digits to the right of the decimal is 5.

- NRf

NRf is a generic term that includes NR1, NR2, and NR3.

- Numeric

A numeric parameter such as a decimal point, optional prefix, or measurement unit.

The syntax as a numeric representation is the same as NRf.

MINimum , MAXimum and DEFault are available as substitutes for declaring certain values.

Units such as V, A, and W can also be used in a numeric parameter.

If a value that cannot be assigned is entered, the device rounds the value to the closest possible value.

IMPedance:AVERage:MOVing:COUNt 300

Retern 256 in response to IMP:AVER:MOV:COUN? as moving average count range is 1 to 256.

Special form numeric parameter

The special form numeric parameters MINimum , MAXimum and DEFault can be used as substitutes for limit values when the parameter is numeric. In the example below, the current limit is set to the minimum value.

SOURce:CURRent MINimum

The minimum and maximum values can be inquired for most parameters using queries.

SOURce:CURRent? MIN

SOURce:CURRent? MAX

Measurement unit

Below are the default measurement units.

  • V (voltage) • A (current)
  • W (power) • OHM (resistance)
  • DEG (degrees) • HR (hour)
  • MIN (minute) • S (second)
  • PCT (%) • HZ (frequency)

 

The following optional prefixes are supported.

  • M (milli) • K (kilo) • U (micro)

NOTE

• The unit symbols in the International System of Units (SI) contain lowercase characters. The IEEE standard uses uppercase characters. SCPI commands are not case-sensitive.

• Commands are accepted even if a measurement unit are not specified.

• To enter "μ" in the data, use "U" instead.